Crafty Maria Tutorials

This 3D pumpkin made with stacked layers of rosettes is approximately 7 1/2 by 6" in size and makes a great table decoration or a decoration for a craft show table.

Supplies:
1.  5 sheets of 12 by 12 Tangerine Tango card stock
2.  1 sheet Crumb Cake card stock
3.  Very Vanilla Card Stock
4.  Scoring board
5. Adhesive
6. Stamp set:  Delicate Doilies
7. Inks:  Early Espresso, Chocolate Chip, Summer starfruit, Soft Suede
8.  Hot glue gun
9.  Autumn Accents die and Big Shot
10.  Paper Crimper

Method:
1.  Randomly stamp images of doilies in different colours on the 5 sheets of Tangerine Tango card stock.  Cover the card stock with the images.

2.  To save yourself time, score each 12 by 12 piece of card stock as a whole, scoring every 1/2".

3.  Then cut it into the desired strips.

  To make this stack into a sphere shape requires making rosettes of graduating sizes.  The strip sizes and number of each strip are listed below.
Note:  Each rosette is make with 2 strips of equal width, so cut two of each size.

Number and size of paper strips needed to complete the pumpkin rosettes

Strip width	# Strips	# Rosettes
2 inches	2	1 (for the bottom of the stack)
2-1/4 inches	4	2
2-1/2 inches	4	2
2-3/4 inches	4	2
2-7/8 inches	4	2
3 inches	2	2

4.  Accordian fold all strips and create your rosettes.  I will not be including instructions on how to make rosettes.

5.  Once you have a stack of rosettes, apply hot glue to the center disk of cardstock on each one and adhere them together.  Start with the smallest rosette and stack gradually larger circles until you've used the largest one, and then start decreasing.  Once you've used all your rosettes, you'll have your base pumpkin shape completed.
Here is the order to follow:

 

1. Bottom of the stack: 2-inch rosette
2. Next up: 2-1/4 inch
3. 2-1/2 inch
4. 2-3/4 inch
5. 2-7/8 inch
6. 3 inch
7. 2-7/8 inch
8. 2-3/4 inch
9. 2-1/2 inch

                                                                                                                                                                    Pumpkin Stem                                                                                                                                  1. 1. 1. Cut two 1 1/2 by 12 strips of Crumb Cake card stock.  Apply tombo glue to one end and start rolling it into a tight cylinder.  When close to the end of the first strip, glue in the second piece and keep rolling.  Wrap rubber bands around the roll until it is dry.

 

2.  Cut another 1 1/2 by 12" Crumb Cake card stock and snip fringes along its entire length.  Draw a line along the top as a guide for your fringe and for gluing.

3.  Die cut 3 maple leaves in Very Vanilla using the Autumn accents die and the Big Shot.  Roll each leaf through the Crimper and then sponge each leaf with Old Olive, Tangerine Tango and Real Red.  Spritz each leaf with water to allow the colours to blend.  Allow to dry.